Wood Veneer Woven Lampshade
Designed by Kathleen Hauck
Tools:
1802913 – Soft Cut Premium Line Scissors
1802730 – Aluminium Ruler
1802521 – Knife with Professional Blade
1802526 – Craft Mat
1804102 – Hot Glue Gun 55 W for ø 11.2mm
1805005 – Glue Sticks
Materials:
2213015 – Lampshade frame, round 15cm/ø 15cm
2002201 – Waxed Cotton Cord, ø 1mm, 100m, white
3480120 – Wood Veneer, 20cm x 1.25cm, natural
2690000 – Electric Light Holder with switch
In addition: pencil, bulb
Step 1. Cut 12 pieces of waxed cotton cord approx. 40cm long. Wrap a piece of cord in the middle between two struts of the frame and tie a knot. Then tie a piece of cord in the middle between the first cord and a strut. Repeat for the other side of the first cord. Trim the excess cords. Repeat around the lampshade frame so that you end up with 3 cords even distributed between all the struts.
Step 2. Cut a 50cm long piece of wood veneer. Cut two 3cm wide strips and six 2cm wide strips from this piece. Starting with a 3cm wide strip, position the end behind one of the struts. Weave the strip in and out of the cotton cords and struts. Due to the even number of struts/cords (16), the wood veneer strip will end up exactly at the beginning (i.e. behind a strut). Glue the end of the strip to the beginning (behind the strut) using a hot glue gun. Continue in the same way with a 2cm wide strip, except make sure that it begins in front of the strut rather than behind. Continue in the same vein with three more 2cm wide strips and finally a 3cm wide strip, alternating where you start i.e. in front or behind a strut.
Step 3. Use the hot glue gun to stick the two remaining 2cm strips around the top and bottom of the frame to hide it. Attach the electric light holder to the frame and insert the bulb.